Personnel Platform R e p l a c e m e n t

TM 9-6115-652--14&P

Installation.

(1)

Position fender (4) on trailer.

(2)

Insert one screw (10) with flat washer (11) through lower outside edge of fender (4) into rear step (13),

and insert one screw (6) with flat washer (7) through lower outside edge offender (4) into front step (9).

Install one washer (11) and one nut (12) on screw (10), and one washer (7) and one nut (8) on screw

(3)

(6). Tighten hardware.

(4)

Insert five screws (1) with flat washers (2) down through fender (4) into trailer frame (5).

Working under fender, install one flat washer (2) and one nut (3) on each screw(1) and tighten.

(5)

Insert six screws (6) with flat washers (7) through fender (4) into front step (9). Install one washer (7)

(6)

and one nut (8) on each screw (6) and tighten.

(7)

Insert four screws (10) with flat washers (11) through fender (4) into rear step (13). Install one washer

(11) and one nut (12) on each screw (10) and

tighten.

4-23. Personnel

Platform

R e p l a c e m e n t . (See figure 4-11). This platform is mounted on the rear of the

trailer to facilitate access to generator set controls and indicators.

a . Removal.

(1) Remove two screws (1, figure 4-11), four flat washers (2) and two self-locking nuts (3) securing platform

(4) to mounting brackets (5).

Support platform while removing anchors. When anchors are removed, platform will

drop.

Remove two platform anchors (6) by pushing in on button on head of pin while pulling pin out of

(2)

mounting hole.

NOTE

M o u n t i n g brackets are fastened with self-locking nuts. Removal may damage locking

capability when reinstalled. Do not remove mounting brackets unless they are damaged.

Remove three screws (7) three flat washers (8) and three self-locking nuts (9) from each mounting

(3)

bracket (5) and take mounting brackets off of trailer frame (10).

4-22