Click here to make tpub.com your Home Page

Page Title: Fender Replacement
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Back
Figure 4-9. rear Step And Bracket Replacement
Up
TM-9-6115-652-14-P Power Unit PU-760/M (NSN 6115-00-394-9581) MEP-114A 30 Kw 400 Hz Generator Set Manual
Next
Figure 4-10. Fender Replacement.

TM
9-6115-652-14&P
b. I n s t a l l a t i o n .
(1) If rear step bracket (4) and step (11) were separated during removal, aline bracket and step and install
three screws (16), three flat washers (17), three nuts (18) and tighten.
(2)
Position rear step (11) on trailer frame (6).
(3)
Secure rear step (11) to trailer frame (6) with two screws (8), four flat washers (9) and two nuts (10).
(4)
Secure rear step (11) to fender (15) with five screws (12), ten flat washers (13) and five nuts (14).
Aline two mounting holes in rear step bracket (4) with holes in trailer frame (6) under taillight (7) and
(5)
insert two screws (1).
Slide S-hook at chain end of platform anchor (5) onto threaded end of lower screw (1) inside trailer
(6)
frame (6).
Install one flat washer (2) and one nut (3) on each screw (1) and tighten.
(7)
4 - 2 2 . F e n d e r R e p l a c e m e n t . (See figure 4-10.) The fenders on the trailer are symmetrical, and
replacement procedures are the same for both.
a. R e m o v a l .
(1) Remove five screws (1, figure 4-10), ten flat washers (2) and five nuts (3) securing fender (4) to trailer
frame (5).
There are five sets of hardware securing fender to rear step and seven sets of hardware
securing fender to front step. This hardware should be removed in sequence from trailer
frame outward. In this way, last two screws on front and rear lower fender edge will
support fender until you are out from underneath.
(2) Remove six screws (6), 12 flat washers (7) and six nuts (8) securing fender (4) to front step (9).
(3) Remove four screws (1), eight flat washers (11) and four nuts (12) securing fender (4) to rear step (13).
S u p p o r t fender while removing remaining two screws. When screws are removed, fender
will drop, causing injury to personnel.
(4) Remove one screw (6), two flat washers (7) and one nut (8) securing fender (4) to front step (9).
(5) Remove one screw (10), two flat washers (11) and one nut (12) securing fender (4) to rear step (13).
(6) Remove fender (4).
4-20

Privacy Statement - Press Release - Copyright Information. - Contact Us