Rear Step and Bracket Replacement

9-6115-652-14&P

(1)

Position front step (14) and spacers (32) and (33) on cross brace channels (31) and trailer frame (9).

Insert clevis on handbrake cable (3) through hole in front step (14).

Insert

four screws (23, 24 and 25) with flat washers (26) through front

step (14) and trailer frame (9).

(2)

Insert three screws (28) with flat washers (29) through front step (14) and trailer cross brace

(3)

channels (31).

(4)

Working under step, install one nut (30) on each screw (28) securing front step (14) to cross brace

channels (31) and install one flat washer (26) and one nut (27) on each screw (23, 24 and 25) securing

step to trailer frame (9). Tighten seven sets of hardware.

Secure front step (14) to fender (22) with seven screws (19), 14 flat washers (20) and seven nuts (21).

(5)

Insert screw (15) with flat washer (16) through handbrake bracket (8), front step (14) and cross brace

(6)

channel (31). Install Iockwasher (17) and nut (18) on screw from underneath and tighten.

(7)

Insert two screws (5) with flat washers (6) through handbrake bracket (8) and trailer frame (9). Install

one nut (7) on each screw and tighten.

Insert two screws (10) through front step (14) and handbrake cable bracket (13). Install one flat washer

(8)

(11) and one nut (12) on each screw and tighten.

Position clevis on handbrake cable (3) on handbrake lever mechanism (4). Insert clevis pin (2) and

(9)

secure with cotter pin (1).

NOTE

When installing roadside front step, omit steps (10) and (11).

Install accessory box (paragraph 4-18, b).

(10)

Install fuel can brackets (paragraph 4-17, b).

(11)

4-21. Rear Step and Bracket Replacement. (See figure 4-9.) The roadside and curbside rear steps are

symmetrical, and replacement procedures are the same for both.

a. R e m o v a l .

(1) Remove two screws (1, figure 4-9), two flat washers (2) and two nuts (3) securing rear step bracket (4)

and platform anchor (5) to trailer frame (6) under taillight (7).

(2) Remove two screws (8), four flat washers (9) and two nuts (10) securing rear step (11) to trailer

frame (6).

(3) Remove five screws (12), ten flat washers (13) and five nuts (14) securing rear step (11) to fender (15).

Remove rear step from trailer.

4-18