Section VIII. MAINTENANCE OF POWER UNIT TRAILER

TM 9-6115-652-14&P

Section VIII. MAINTENANCE OF POWER UNIT TRAILER

4-16. G e n e r a l . This section of the manual contains unit level maintenance procedures for components of the

M200A1 trailer added when the trailer is used as part of the PU-760/M power unit. These components are not

covered in the overall trailer maintenance manual. For all other unit maintenance procedures on the trailer, refer

to TM 9-2330-205-14&P. When power unit has been painted in camouflage, replacement parts must be painted

to match authorized patterns and colors as specified in TB 43-0147. Application of camouflage paint shall be

done in accordance with MIL-C-53072.

Before performing any maintenance that requires climbing on or under trailer, set trailer

handbrakes, chock both wheels, and lower rear leveling jacks. Injury to personnel could

result from trailer suddenly rolling or tipping.

4 - 1 7 . F u e l C a n B r a c k e t R e p l a c e m e n t . (See figure 4-5.) There are two fuel can brackets supplied with

t h e PU-760/M. The brackets are mounted on top of the curbside front step. Replacement procedures described

below are the same for both.

Figure 4-5. Fuel Can Bracket Replacement.

a. R e m o v a l .

(1) Remove four screws (1, figure 4-5), four self-locking nuts (2) and four flat washers (3) securing bracket

(4) to step (5).

( 2 ) Remove bracket (4) from step (5).

4-13