WARNING

9-6115-652-14&P

All specific cautions and warnings contained in this manual shall be strictly adhered to.

Otherwise, severe injury, death and/or damage to the equipment may result.

HIGH

VOLTAGE

is produced when this power unit is in operation.

DEATH

or severe burns may result

if personnel

fail

to observe safety precautions. Do not operate this

power unit

until the ground terminal stud has been connected to a suitable ground. Disconnect

the battery ground cable on the generator set before removing and installing components on the

engine or in the electrical

control panel system. Remove all rings, watches, and other jewelry

when performing maintenance on this equipment. Loose fitting clothing should be secured to

prevent

it catching moving parts. Do not attempt to service or otherwise make any adjustments,

connections

reconnection

of wires or cables until

generator set is shut down and completely

de-energized.

DANGEROUS GASES

Batteries

generate explosive gas during charging: therefore, utilize extreme caution. Do not

smoke,

or use open flame in the vicinity of the generator set when servicing batteries.

Exhaust discharge contains noxious and deadly fumes. Do not operate power unit generator sets

in enclosed areas unless exhaust discharge is properly vented to the outside.

To avoid sparking between filler nozzle and fuel tank, always maintain metal to metal contact

between filler nozzle and fuel tank when filling generator set fuel tank.

Do not smoke or use open

flame

the vicinity of the power unit while refueling generator sets.

LIQUIDS UNDER HIGH PRESSURE

are generated as a result of operation of the power unit generator set.

Do not expose any part of

the body to a high pressure leak in the fuel injection system.

NOISE

Operating noise level of the generator

set can cause hearing damage.

Ear protectors,

recommended by the medical or safety officer, must be worn when working near this power unit.

Clean parts in a well-ventilated area. Avoid inhalation of solvent fumes and prolonged exposure

of skin to cleaning solvent. Wash exposed skin thoroughly.

Dry

cleaning solvent (PD-680) used

to clean parts is potentially dangerous

to personnel

and property.

Do not use near open flame or

excessive heat. Flash point of solvent is 100°F to 138°F (38°C to 59°C).