 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
per MIL-W-8611. The exhaust ejector is
(4) Apply primer coat MIL-P-53030,
and allow to air dry.
constructed of 304/321 SST; weld per
MIL-STD-1261 Class I.
Welding allowed
(5) Apply final coat of lusterless
on engine components is covered in chap-
forest green MIL-C-46168, and allow to
ter 9.
air dry.
Assemblies. Riveted
c. Riveted
assemblies (door hinges, latches, and
e. Corrosion Control.
attaching hardware) may be replaced as
follows:
(1) Drill out rivets using care
not to enlarge holes.
Do not spray electrical connector
pins and receptacle contacts with
any corrosion preventive compound
(2) Clean area under riveted as-
sembly to remove all signs of rust or
(CPC) other than MIL-C-81309 Type
III. Otherwise, equipment mal-
corrosion.
functions may occur, or connector
may be bonded to receptacle.
(3) Touchup paint if required.
Pins/
Connector
(4) Install assembly
(1) Electrical
and
rivet.
Disconnect all electrical
Touchup paint as required.
Contacts.
connectors and spray corrosion preven-
tive compound (CPC) MIL-C-81309 Type III
d. Painting. Standard
(NSN 8030-00-546-8637) on connector pins
surface
and mating receptacle contacts. Recon-
preparation and painting procedures per
MIL-T-704 are used for the frame and
nect electrical connectors.
housing, and propulsion system compo-
nents. Whenever it becomes necessary to
remove paint to bare metal it is nec-
essary to clean and smooth the rough
DO not spray CPC MIL-C-85054 Type
edges or remaining paint, treat the bare
I on electrical connector pins or
metal, and then paint the surfaces.
Do not paint surfaces not previously
contacts, components subject to
painted, such as anodized or galvanized
heat (engine), or moving Parts
Finish paint coat on frame
such as door hinges.
surfaces.
and housing, and propulsion system com-
Spray
ponents shall be lusterless forest
(2) Electrical Terminals.
green, type A per Fed-Std 595 and MIL-
corrosion preventive compound (CPC MIL-
C-46168.
C-85054 Type I (NSN 8030-01-041-1596) on
following electrical terminals (after
cleaning):
(1) Ensure surface is free of all
rust or corrosion.
(a) Behind control panel - indi-
(2) Clean surface to be painted
cator lights, switches, and meters.
using solvent cleaner to ensure it is
free from all oil and grease.
(b) Electrical compartment com-
ponent terminals.
(3) Pretreat area to be painted
with a wash primer MIL-P-15328 within 4
(c) Upper and lower tray compo-
nent terminals.
hours after cleaning. Allow to air dry.
2-25
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals