EXTREMELY HOT AIR UNDER PRESSURE

TM 55-1730-229-34

TO 35C2-3-473-2

Allow pneumatic hose to cool before

Is generated by the AGPU pneumatic system.

touching. Wear goggles and eve protection (goggles or face shield) when operating

pneumatic system.

Never set PNEUMATIC POWER switch to ON unless pneumatic hose fitting is securely

attached to aircraft. The hose will attempt to straighten out with power applied

and whip around violently if not securely attached to aircraft.

NOISE

Operating noise level of the AGPU can cause hearing damage. Ear protectors, as

recommended by the medical or safety officer, must be worn when working near the

AGPU.

CLEANING SOLVENTS

When using solvents, clean parts in a well-ventilated area. Avoid inhalation of

solvent fumes and prolonged exposure to skin to cleaning solvent. Wash exposed skin

thoroughly. Dry cleaning solvent (Fed. Spec. P-D-680) used to clean parts is poten-

tially dangerous to personnel and property. DO not use near open flame or excessive

heat. Flash point of solvent is 100°F. to 138°F. (38°C. to 59°C.).

OPEN ACCESS DOORS

May be blown shut if AGPU is operated in close proximity of hovering or taxiing

aircraft.

ACETONE,O-A-51 (NSN 6810-00-184-4796) is extremely flamable and toxic to eyes, skin,

and respiratory tract. Wear protective gloves and goggles/face shield. Avoid

repeated orprolonged contact. Use only in well-ventilated areas (or use approved

respirator as determined by local safety/industrial hygiene personnel). Keep

away from open flames, sparks, hot surfaces or other sources of ignition.

Breathing Asbestos Fibers/Dust can cause Cancer and Lung Disease. Consult local

industrial Hygene/Safety representative for specific Asbestos operating procedures.

Do not work with Asbestos materials unless assigned protective equipment is worn.

b Change 5