Warning

TM 55-1730-229-34

AG 320A0-MME-000

TO 35C2-3-473-2

TM 1730-34/1

All specific cautions and warnings contained in this manual shall be strictly

adhered to.

Otherwise, severe injury, death and/or damage to the equipment may

result.

HIGH VOLTAGE

is produced when this AGPU is in operation.

DEATH

or severe burns may result if personnel fail to observe safety precautions. Do not

operate the AGPU until the ground terminal stud has been connected to a suitable

ground. Disconnect the battery connector before removing and installing components.

Remove all rings, watches, and other jewelry when performing maintenance on this

Loose fitting clothing should be secured to prevent it catching in

equipment.

moving parts. Do not attempt to service or otherwise make any adjustments, connec-

tions or reconnection of wires or cables until AGPU is shut-down and completely

deenergized.

DANGEROUS GASES

Batteries generate explosive gas during charging: therefore, utilize extreme cau-

tion, do not smoke, or use open flame in the vicinity of the AGPU when servicing

batteries.

Exhaust discharge contains noxious and deadly flames and is very hot. Do not op-

erate AGPU in enclosed areas unless exhaust discharge is properly vented to the

outside. Do not operate under overhangs, helicopter blades, or trees.

To avoid sparking between filler nozzle and fuel tank, always maintain metal to

metal contact between filler nozzle and fuel tank when filling fuel tank.

Do not smoke or use open flame in the vicinity of the AGPU while fueling.

HYDRAULIC FLUID UNDER HIGH PRESSURE

is generated as a result of operation of the AGPU. Do not expose any part of the

body to a high pressure leak in the hydraulic system. Never attempt to connect or

disconnect hydraulic fittings under high pressure. Ensure that hoses are in good

condition, not kinked, and securely connected to aircraft before applying hydraulic

Wear gloves and eye protection (goggles or face shield) when operating

power.

hydraulic system.