Section Ill. REPAIR PARTS, SPECIAL TOOLS, SPECIAL TEST, MEASUREMENT AND D I A G N O S T I C EQUIPMENT (TMDE)

ARMY TM 5-6115-633-14&P

i. Attach power plant to towing vehicle. (Refer to TM 9-2330-213-14&P.)

4-4. Reinstallation After Movement. After movement to a new worksite, install power plant in

accordance with paragraph 4-2.

Section Ill. REPAIR PARTS, SPECIAL TOOLS, SPECIAL TEST, MEASUREMENT AND

D I A G N O S T I C EQUIPMENT (TMDE)

4-5. Tools and Equipment. There are no special tools or equipment required to maintain the

AN/MJQ-18 power plant.

4-6. Maintenance Repair Parts. Repair parts and equipment for maintenance of this power plant are

listed and illustrated in the repair parts and special tools list in Appendix D of this manual.

Section IV. LUBRICATION INSTRUCTIONS

4-7. General. Detailed instructions for the lubrication of the maior components of the power pIant are

contained in the applicable Lubrication Orders (LO's). Refer to DA Pam 310-1 to ensure that the latest

editions of the L.O.'S are used. This section contains lubrication instructions that are not included in

the Lubrication Orders.

4-8.

Generator Lubrication. Refer to TM 5-6115-585-12.

4.9.

Trailer Assembly Lubrication.

a. Trailer Lubrication. Refer to TM 9-2330-213-14&P for trailer Lubrication Order.

b. Leg Prop Assembly Lubrication. The rear leg prop assembly is a modification to the standard

M103A3 trailer and, as such, does not appear in the associated LO. Semiannually lubricate leg prop

assembly as follows:

WARNING

Clean parts in a well-ventilated area. Avoid inhalation of solvent fumes and

prolonged exposure of skin to cleaning solvent. Wash exposed skin tho-

roughly. Dry cleaning solvent (P-D-680) used to clean parts is potentially

dangerous to personnel and property. Do not use near open flame or

excessive heat. Flash point of solvent is 100°F. to 138°F. (38°C. to 59°C.).

(1) Clean hydraulic lubrication fitting and area around lubrication points with P-D-680 or

equivalent.

(2) Inject sufficient GAA grease into hydraulic fitting to lubricate screw theads inside leg prop

assembly.

NOTE

Refer to Lubrication Order in TM 9-2330-213-14&P for lubricating oils

specified for use within different anticipated temperature ranges.

(3) Apply OE lubricating oil to both ends of leg prop assembly pivot shaft.

4-7