STARTER - REPLACE.

TM 5-1730-245-14

4.26 STARTER - REPLACE.

THIS TASK CONSISTS OF: a. Removal

Installation

INITIAL SETUP

Tools:

Equipment Condition:

Toolkit, General Mechanics (item 5, Section III, Appendix B).

Side panels (8, fig. 1-2) removed.

Shop Equipment Automotive Maintenance and Repair:

Battery disconnected. Refer to paragraph 4.19.

Organizational Maintenance, Common No. 1, less power

Cabinet top cover removed. Refer to paragraph 4.16.

(item 6, Section m, Appendix B).

a. Removal. Refer to figure 4-17.

1) Remove nuts (14) and lockwashers (13). Discard lockwashers.

2) Remove screw (5) and lockwasher (6). Tag and remove starter switch wire (4) from starter solenoid

(8).

3) Tag and remove fuel solenoid wire (12) from starter solenoid (8).

4) Tag and remove positive battery cable (3) slave receptacle cable (1) and harness wire (2) from starter

solenoid (8).

5) Support starter (11) and remove screws (9) and flatwashers (10) Remove starter (11).

b. Installation. Refer to figure 4-17.

1) Install the starter (11) using flatwashers (10) mounting bolts (9) and secure to 30 0 ft. lb. (41.0 Nm).

2) Install the wires (1), (2), and (3) and (12) to the starter solenoid. Install lockwashers (13) and nuts (14)

to the starter solenoid and secure to 4.5/8.5 ft lb (5.89/11 77 Nm).

3) Install wire (4) lockwasher (6) and screw (5) to the starter solenoid (8).

Figure 4-17. Starter.

4-33