 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  TM 5-1730-245-14
4.16 CABINET TOP COVER - REPLACE.
THIS TASK CONSISTS OF:
a. Removal
b. Installation
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance and Repair:
Side panels (8, fig. 1-2) removed.
Organizational Maintenance, Common No. 1, less
Battery disconnected. Refer to paragraph
power (item 6, Section III, Appendix B).
4.19.
Material/Parts Required:
Caulking material (item 12, Appendix E)
a. Removal. Refer to figure 4-6.
1) Loosen the clamp bolt (1) on the muffler cap (6) Remove the cap (6).
2) Remove the four screws (2) holding the rain shield (5) In place and remove the rain shield
3) Remove the twenty two screws (3) holding the cover (4) and lift off the cover. Latex caulking
material (item 12, Appendix E) is used as a gasket material on the cover to provide water-tightness.
b. Installation. Refer to figure 4-6.
1) To install the cover (4) apply a bead of latex caulk (Item 12, Appendix E) around the seating surface
and replace the cover (4) with the 22 screws (3)
2) Install the rain shield (5) with the four screws (2).
3) Install the muffler cap (6) and tighten the clamp bolt (1).
Figure 4-6. Top Cover.
4-21
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals