TABLE 4-2. Unit Preventive Maintenance Checks and Services.

TM 5-1730-245-14

e. The "NOT FULLY MISSION CAPABLE IF:" column is the column of Table 4-2 in which entries will be

keyed specifically to checks listed in the "procedures" column for the purpose of identifying, for the check, the

criteria that will cause the equipment to be classified as not ready/available because of inability to perform its

primary Combat Mission. An entry in this column will:

a. Identify conditions that make the equipment not fully mission capable for readiness reporting.

b. Deny use of the equipment until corrective maintenance has been performed

4.12 PMCS Table. The necessary preventive maintenance services to be performed are listed and described

in Table 4-2. Defects discovered during operation of the system should be corrected as soon as possible. All

deficiencies and shortcomings will be recorded, together with the corrective action taken, on DA Form 2404

(Equipment Inspection and Maintenance Worksheet) as soon as possible.

TABLE 4-2. Unit Preventive Maintenance Checks and Services.

ITEM

INTERVAL

LOCATION

PROCEDURE

NOT FULLY MISSION

NO.

ITEM TO

CAPABLE IF:

CHECK/SERVICE

125 hours

Engine Oil and

Drain and refill. Refer to

Oil dirty.

Filter

Paragraph 4.2.

125 hours

Hydraulic Fluid

Replace whenever fluid is

Clogged filter Is permitting

Filter

drained or after component/tool

dirty fluid to bypass.

failure Refer to paragraph 4.3.

125 hours

Air Cleaner

Clean element with

Element clogged.

compressed air.

250 hours

Air Cleaner

Replace element..

Element clogged.

500 hours

Fuel Filter

Replace element Refer to

Element clogged.

paragraph 4.23.

500 hours

Engine

Inspect for deterioration.

Deteriorated rubber.

Shockmounts

Report to Direct Support

Maintenance.

2000 hours

Fan Belt

Replace.

NOTE

Tension on a new radiator fan belt should be checked after installation and after

the first 25 hours of operation Refer to paragraph 4.21.

4-9