Support plate replacement.

TM 32-5811-018-14&P

Secure support plate (25) to

(12) Support plate replacement.

chassis (4) with three screws (24) , then replace bottom

cover (3) in accordance with paragraph 6-8b(1).

(13) Exhaust filter replacement.

(a) Install RF contact strip, (item 6, App. D), to the exhaust

filter with pressure sensitive tape, type 467 (item 18,

App. D).

(b) Secure exhaust filter (27) to the side of the chassis with

ten screws (26).

Install bottom cover (3) on chassis (4) in accordance with

(c)

paragraph 6-8b(1).

(14) Time meter Ml replacement.

(a) Solder wires, as tagged, to terminals of time meter (33).

(b) Slide heatshrink tubing (item 12, App. D) over connec-

tions and remove tags.

(29), lock washers (30), flat washers (31), and nuts

(32).

(d) Install top cover (2) on chassis (4) in accordance with

paragraph 6-8b(1).

(15) Angle bracket replacement.

(a) Secure bracket (46) to studs on rear of front panel (9)

with four nuts (43) , lock washers (44) , and flat washers

(45).

(b) Replace front panel in accordance with paragraph 6-8b(19)

steps (f), (g), and (h).

(16) Connector replacement. The number of connectors varies

with the power supply, but the replacement procedure is the

same.

(a) Use insertion tool to insert wires into connector (38) as

marked during removal. Remove tags.

(b) Secure connector (38) to front panel (9) using four

screws (34), flat washers (35) , lock washers (36), and

nuts (37) with terminal lug (59).

front panel (9) to chassis with eight screws (9A) and

secure to heatsink with two screws (9E).

(d) Replace holddown hooks (8) in accordance with paragraph

6-8b(6).

(e) Replace top and bottom covers (2 and 3) in accordance

with paragraph 6-8b(1).

(17) Handle replacement.

(a) Secure handle (42) on front panel (9) with two screws

(41).

(b) After ensuring the RF contact strip is intact, secure

front panel to chassis with eight screws (9A) and secure

to heatsink with two screws (9E).

6-8b(6).

6-18