Section I. INTRODUCTION

TM 11-6625-3000-24P

SECTION I

INTRODUCTION

Code

Definition

Scope

This manual lists spares and repair parts; special tools;

XA-- is

not procured or stocked because the

special test, measurement, and diagnostic equipment

requirements for the item will result in the

(TMDE). and other special support equipment required for

replacement of the next higher assembly.

performance of organizational, direct support, and general

XD-- A support item that is not stocked. When

support maintenance of the PP-7762, /U, PP-7763:'U and

required. item will be procured through normal

PP-7763/U. It authorizes the requisitioning and issue of

supply channels.

spares and repair parts as indicated by the source and

maintenance codes.

NOTE

General

Cannibalization or salvage may be

This Repair Parts and Special Tools List is divided into the

used as a source of supply for any

following sections:

items source coded above except

those coded XA and aircraft support

a. Section II. Repair Parts List. A list of spares and

items as restricted by AR 750-1.

repair parts authorized for use in the performance of

maintenance. The list also includes parts which must he

(2) Maintenance code Maintenance codes are

removed for replacement of the authorized parts. Parts

assigned to indicate the levels of maintenance

lists are composed of functional groups in numeric

authorized to USE and REPAIR support items. The

sequence, with the parts in each group listed in figure and

maintenance codes are entered in the third and fourth

item number sequence.

positions of the Uniform SMR Code format as follows:

b. Section III. Special Tools List. Not applicable.

(a) The maintenance code entered in the

c. Section IV. National Stock Number and Part

third position will indicate the lowest maintenance level

Number Index. A list, in National item identification number

authorized to remove, replace, and use the support

(NIIN) sequence, of all National stock numbers (NSN)

item. The maintenance code entered in the third

appearing in the listings, followed by a list, in alphameric

position will indicate one of the following levels of

sequence, of all part numbers appearing in the listings.

maintenance:

National stock numbers and part numbers are cross-

referenced to each illustration figure and item number

Code

Application/Explanation

appearance.

H-- Support item is removed, replaced, used at the

Explanation of Columns

general support level.

Illustration. This column is divided as follows:

(b) The maintenance code entered in the

(1) Figure number. Indicates the figure

fourth positions indicates whether the item is to be

number of the illustration on which the item is shown.

repaired and identifies the lowest maintenance level

(2) Item number. The number used to identify

with the capability to perform complete repair (i.e., all

item called out in the illustration.

authorized maintenance functions). This position will

Source Maintenance, and Recoverability

contain one of the following maintenance codes:

(SMR) codes.

(1) Source code. Source codes indicate the

Code

Application/Explanation

manner of acquiring support items for maintenance, repair.

H-- The lowest maintenance level capable of

or overhaul of end items. Source codes are entered in the

complete repair of the support item is the

first and second positions of the Uniform SIR Code format

general support level.

as follows:

Z-- Nonreparable. No repair is authorized.

Code

Definition

(3) Recoverability code. Recoverabilitv codes

PA-- Item procured and stocked for anticipated or known

are assigned to support items to indicate the

usage.

disposition action on unserviceable items.

The

recoverability code is entered in the fifth position of the

Uniform SMR Code format as follows: