Tool and Test Equipment Requirements (sec III)

TM 11-6130-266-15

d. Column 4, Maintenance Category. Column 4

specifies, by the listing of a "worktime" figure in the

B-4. Tool and Test Equipment Requirements (sec III)

appropriate subcolumn(s), the lowest level of

maintenance authorized to perform the function listed in

a. Tool or Test Equipment Reference Code. The

column 3. This figure represents the active time

numbers in this column coincide with the numbers used

required to perform that maintenance function at the

in the tools and equipment column of the MAC. The

indicated category of maintenance. If the number or

numbers indicate the applicable tool or test equipment

complexity of the tasks within the listed maintenance

for the maintenance functions.

function vary at different maintenance categories,

appropriate "worktime" figures will be shown for each

b. Maintenance Category. The codes in this

category. The number of task-hours specified by the

column indicate the maintenance category allocated the

"worktime" figure represents the average time required

tool or test equipment.

to restore an item (assembly, subassembly, component,

module, end item or system) to a serviceable condition

c. Nomenclature. This column lists the noun name

under typical field operating conditions. This time

and nomenclature of the tools and test equipment

includes preparation time, troubleshooting time, and

required to perform the maintenance functions.

quality assurance/quality control time in addition to the

time required to perform the specific tasks identified for

d. National/NATO Stock Number. This column lists

the maintenance functions authorized in the

the National/NATO stock number of the specific tool or

maintenance allocation chart. Subcolumns of column 4

test equipment.

are as follows:

e. Tool Number. This column lists the

C-Operator/Crew

manufacturer's part number of the tool followed by the

O-Organizational

Federal Supply Code for manufacturers (5 digit) in

F-Direct Support

parentheses.

H-General Support

D-Depot

B-5. Remarks (sec IV)

e. Column 5, Tools and Equipment. Column 5

a. Reference Code. This code refers to the

specifies by code, those common tool sets (not

appropriate item in section II, column 6.

individual tools) and special tools, test, and support

equipment required to perform the designated function.

b. Remarks. This column provides the required

f. Column 6, Remarks. Column 6 contains an

explanatory information necessary to clarify items

alphabetic code which leads to the remark in section IV,

appearing in section II.

Remarks, which is pertinent to the item opposite the

particular code.

(Next printed page is B-3.)

B-2 Change 3