Chapter 6. GENERAL SUPPORT TESTING PROCEDURES

TM 11-6130-266-15

CHAPTER 6

GENERAL SUPPORT TESTING PROCEDURES

a. Test Equipment.

6-1. General

a. Test procedures are prepared for use by

Electronics Field Maintenance Shops and Electronic

Service Organizations responsible for general support

(1) Digital, Voltmeter AN/GSM-64.

maintenance of electronic equipment to determine the

acceptability of repaired equipment. These procedures

(2) Voltmeter, Meter ME-30A/V.

set forth specific requirements that repaired equipment

must meet before it is returned to the using organization.

(3) Multimeter, Weston Instruments Model

A summary of the performance standards is given in

281.

paragraph 6-8.

(4) Multimeter TS-352B/U.

b. Comply with the instructions preceding each

chart before proceeding to the chart. Perform each step

b. Tools. The only tools necessary for these

in sequence. Do not vary the sequence. For each step,

checks are those contained in Tool Kit, Electronic

perform all the actions required in the Control settings

Equipment TK-100/G.

column; then perform each specific test procedure and

verify it against its performance standard.

c. Other Equipment .

(1) Transformer Variable TF-171A.

6-2. Test Equipment, Tools, and Materials

(2) Simulator, Battery Variable Load Bank

NOTE

(FMC63743, Type K48149).

Use tools and test equipment listed

(3) Connector, Electrical, 2 required

below until the tools and test

(FSN 5935-921-3398).

equipment listed in Appendix A

become available.

6-3. Physical Tests and Inspection

All test equipment, tools, materials, and other equipment

required to perform the test procedures given in this

a. Test Equipment and Materials. None required.

chapter are listed in a, b and c below.

b. Test Connections and Conditions.

(1) No connections necessary.

(2) Remove panels and covers as necessary

for visual and actual access to all components.

Change 3 6-1