Chapter 2. INSTALLATION AND OPERATING INSTRUCTIONS

TM 11-6130-266-15

CHAPTER 2

INSTALLATION AND OPERATING INSTRUCTIONS

Section I. INSTALLATION

(2) Check to see that the equipment is

2-1. Packaging Data

complete as listed on the packing slip. If a packing slip

When packaged for shipment, the power supply is

is not available, check the equipment against the chart in

packed as follows:

paragraph 1-6. Report all discrepancies in accordance

with TM 38-750. Shortage of a minor assembly or part

a. The power supply is fastened to a plywood

that does not affect proper functioning of the equipment

sheet by bolts and nuts at each corner.

should not prevent use of the equipment.

b. The ac and dc. power cords are placed in a

sealed plastic bag and packed behind the power supply.

c. The power supply, technical manual, and cords

are placed in the fiberboard box and enclosed by a

sleeve.

d. A top pad is placed over the equipment, then the

two sealed bags are placed on the pad.

e. The box is now closed and taped at all four

corners.

2-2. Unpacking and Checking

a. Unpacking.

To unpack the power supply

(fig. 2-1), proceed as follows:

(1) Cut the tape sealing the top of the

fiberboard box and fold back the flaps.

(2) Remove the manual bag.

(3) Remove the top pad.

(4) Lift out the ac and de power cords.

(5) Cut the tape at the four corners of the box

and fold back each side of the box until the four

fastening bolts are accessible.

(6) Remove the sleeve from the power

supply.

(7) Remove the nuts and bolts that secure the

power supply to the plywood.

(8) Lift the power supply off the plywood and

place it in an area for easy checking.

b. Checking.

(1) Inspect the equipment for damage

incurred during shipment. If the equipment has been

damaged, report the damage on DD Form 6 (para 1-3).

Figure 2-1. Power Supply PP-6224/ U, typical

packaging.

2-1