Figure 32. Connection diagram for output power test at 440-volt input.

TM 11-6130-243-35-1

Figure 32. Connection diagram for output power test at 440-volt input.

A/U meter reading at T1, T2, and

(2) Power cable (as fabricated).

T3 is greater than 10 megohms.

(3) Mating connector (FSN 5935-236-

4640).

(4) Disconnect the ZM-21A/U from the

PP-4606A/G.

b. Test Connections and Conditions. Connect

the equipment as shown in figure 3-2. (This

36. Output Power Test at 440-Volt Input

test is written for operation of the power sup-

a. Material.

ply at 440 volts ac.) Do not connect the load

to the power supply until instructed to do so in

(1) Resistance element, 0.41-ohm, 3,400 -

the procedure given in c below.

watt; 3 each.

c. Procedure.

3-5