Click here to make tpub.com your Home Page

Page Title: Chapter 6. GENERAL SUPPORT TESTING PROCEDURES
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Back
Figure 5-4. Base assembly, exploded view
Up
TM-11-6130-243-14-2 Power Supply PP-4606B/G (NSN6130-00-504-0327) Manual
Next
Procedure

TM 11-6130-243-14-2
GENERAL SUPPORT TESTING PROCEDURES
Federal stock No.
Nomenclature
Technical manual
6-1. General Instructions
6625-242-5023 . . . TM 11-6625-366-15
Multimeter
a. Testing procedures are prepared for use by
TS-352B/U.
Signal Field Maintenance Shops and Signal
4910­092-9136 . . . None
Low Voltage
Circuit
Service Organizations responsible for general sup-
Tester
port maintenance of electronics equipment to de-
TV-100.
termine the acceptability of repaired equipment.
Voltmeter,
6626-669-0742 . . . . TM 11-6625­320-12
These procedures set forth specific requirements
Meter
that repaired equipment must meet before it is
ME-30(*)/
U.*
returned to the using organization. These proce-
6625-246-6880 . . . TM 11-2050
Ohmmeter
dures may also be used as a guide for testing
ZM-21A/U.
equipment that has been repaired at direct sup-
--
* Indicates Volmeter, Meter, ME-30A/U or Voltmeter,
port, if the proper tools and test equipments are
Electronic, ME-30B/U, ME-30C/U, or ME-30E/U.
available. A usmmary of the performance stand-
ards is given in paragraph 6-7.
b. Tools. All the tools required are included in
Tool Kits, Electronic Equipment TK-100/G
b. Comply with the instructions preceding each
and TK-105/G.
chart before proceeding to the chart. Perform
each step in sequence. Do not vary the sequence.
c. Materials.
For each step, perform all the actions required
in the Control settings column; then perform
Nomenclature
Federal stock No.
each specific test procedure and verify it against
Resistance element, 0.41-ohm,
5905-259-5909
its performance standard.
3,400-watt (3 required).
Wire, electrical stranded; #0 AWG . . . . 6145-822-8431
Mating connector (dc output) . . . . . . . . .  5935--236-4640
6-2. Test Equipment, Tools, und Materials
All test equipment, tools, and materials required
6-3. Physical Tests and Inspections
to perform the testing procedures given in this
chapter are listed in a, b, and c below.
a. Test Equipment and Materials. None re-
quired.
a. Test Equipment.
b. Test Connections and Conditions. No con-
Federal stock No.
Technical
manual
Nomenclature
nections are necessary. Remove lower front and
6625-237-9312
Ammeter
upper and lower rear panels.
ME-65/U.

Privacy Statement - Press Release - Copyright Information. - Contact Us