Chapter 2. INSTALLATION AND OPERATING INSTRUCTIONS

TM 11-6130-243-14-2

CHAPTER 2

INSTALLATION AND OPERATING INSTRUCTIONS

Section I. SERVICE UPON RECEIPT OF EQUIPMENT

2-1.

Unpacking

(fig. 2-1)

a. Packaging Data. When packed for ship-

ment, the power supply is placed in protective

material and packed in a wooden packing case.

A typical wooden packing case and its contents

are shown in figure 2-1. The volume is 26 cubic

feet and the total weight is 372 pounds.

b. Removing Contents (fig. 2-1)

WARNING

Avoid personal injury. Power Supply

PP-4606B/G weighs 325 pounds; be careful

when moving. A mechanical lift is required.

(1) Cut and remove the metal straps (4).

(2) Remove the nails that secure the sides of the

wooden case (3) to the mounting base (11).

(3) Lift the wooden packing case off the base.

(4) Remove the packing material and lift the

power supply from the mounting base.

(5) Stow all loose material in the wooden packing

case.

(6) Using the handle and the wheels, wheel the

power supply to the area where it is to be used.

2-2. Checking Unpacked Equipment

a. Inspect the equipment for damage that may have

occurred during shipment. If the equipment has been

damaged, fill out and forward SF 364 (para 1-3b).

b. Check to see that the equipment is complete as

listed on the packing slip. If a packing slip is not

available, check the equipment against the chart in

paragraph 1-7. Report all discrepancies in accordance

with TM 38-750. The equipment should be placed in

service even though a minor assembly or part that does

not affect proper functioning is missing.

c. Check to see whether the equipment has been

2-3. Input Power Connections

modified. If the equipment has been modified, the

MWO number will appear on the front panel, near

CAUTION

The ac power input electrical connections are

the nomenclature plate. Check also to see whether all

made by authorized installation personnel;

MWO'S current at the time the equipment is placed in

they should be protected with a fuse and

use have been applied.

c o n t r o l l e d by an e x t e r n a l switch for

NOTE

convenient removal o f power during

Current MWO's applicable to the equipment

maintenance.

are listed in DA Pam 310-4.

2-1

Change 1