Section III. MAINTENANCE PROCEDURES

TM 11-5820-765-34

Section

III.

MAINTENANCE

PROCEDURES

Shut off power supply before performing maintenance.

Capacitors carry a charge after power supply is shut off.

Short out capacitors with shorting rod.

Be careful during removal and replacement.

You can prevent accidental damage to other parts, and you can prevent

potential

short

circuits

caused

dropped

hardware.

When removing and replacing a part, check carefully for loose hardware or

insecure

electrical

connections.

Do not operate equipment until you make these checks.

NOTE

No special tools or procedures are needed to remove and replace power

supply

parts.

2 - 1 0 . REMOVING AND REPLACING PANELS.

The power supply's front, top, and rear panels can be removed to allow maintenance inside the

unit.

To replace top panel, connect fan plug and replace 15 screws, washers, nuts.