POWER PLANT UTILITY, GAS TURBINE ENGINE DRIVEN

L05-6115-586-12

LUBRICATION ORDER

18 OCTOBER 1979 (Supersedes L05-6115-586-12, 18 November 1972)

POWER PLANT UTILITY, GAS TURBINE ENGINE DRIVEN

(LIBBY WELDING CO. MODEL LPU-71)

Reference: TM5-6115-586-12, C9100-IL

Intervals and related task-hour times are based on

Clean parts with SOLVENT dry cleaning, SD-2. Dry

normal hours of operation. The task-hour time specified

before lubricating. Drain crankcase when HOT. Fill and

is the time you need to do all the services prescribed for

check level. The lowest level of maintenance authorized

a particular interval.

Change the interval if your

to lubricate a point Is Indicated by one of the following:

lubricants are contaminated or if you are operating the

equipment under adverse operating conditions, including

longer-than-usual operating hours. You may extend the

You can Improve this publication by calling attention to

interval during periods of low activity, but you must take

errors and by recommending improvements and by

adequate preservation precautions.

stating your reasons for the recommendations. Your

letter or DA Form 2028 (Recommended Changes to

Publications and Forms) should be mailed direct to

'The time specified is the time required to

Commander, U.S. Army Troop Support and Aviation

perform all services at the particular

interval.

Material Readiness Command, ATTN: DRSTS-MTPS,

4300 Goodfellow Blvd., St. Louls MO 63120. A reply will

be furnished direct to you.

FOLD

FOLDI

LUBRICANT · INTERVAL

INTERVAL · LUBRICANT

Oil Fill Cap and Dip-

stick

(Check oil level and

replenish as required)

(See note 2) (0)

Oil Drain Cap

(Drain and refill.)(O)

Oil Filter

(Disassemble, clean

housing, renew element,

and reassemble.)

(See note 1.) (0)

*TOTAL TASK-HR

'TOTAL TASK-HR

INTERVAL

TASK-HR

INTERVAL

TASK-HR

0.1

500

0.6

CARD 1 OF 2