|
| |
Back
4-16. STORAGE BENCH CABINET ASSEMBLY. | Up
TM-5-3610-295-13P-2 Printing Plant Special Warfare Transportable - Press Shelter Manual | Next
Figure 4-6. Storage Bench |
TM 5-3610-295-13&P-2
4-16. STORAGE BENCH CABINET ASSEMBLY. - Continued
b.
Replace Drawer Parts. (See Figure 4-6.)
(1)
Remove screws (1), washers (2), and handle (3) from drawer (4).
(2)
Remove retainer clip (5) from drawer (4).
(3)
Remove spring washer (6) and flat washer (7) from drawer (4).
(4)
Remove knob (8), locking lever (9), and spring (10) from drawer (4).
(5)
Remove rivets (11) and bracket (12) from drawer (4) by drilling or cutting off head and remove bracket.
Remove only if necessary.
(6)
Remove screw (13), flat washer (14), and nut (15) from drawer (4).
(7)
Remove stop latches (16) from drawer (4).
(8)
Position stop latches (16) on drawer (4).
(9)
Install screw (13), flat washer (14), on drawer and tighten nut (15).
(10)
Position bracket (12) on drawer (4).
(11)
Install rivets (11) on drawer (4).
(12)
Insert knob (8) in drawer panel hole.
(13)
Position spring (10) and locking lever (9) onto shaft of knob (8).
(14)
Push knob (8) through rear guide hole of bracket (12).
(15)
Install flat washer (7), spring washer (6), and retainer clip (5) on shaft of knob (8).
(16)
Position handle (3) on front of drawer (4).
(17)
Install screws (1) and washers (2) and tighten screws.
4-27
|
