SECTION III. OPERATOR MAINTENANCE PROCEDURES

TM 5-3610-295-13&P-1

SECTION III. OPERATOR MAINTENANCE PROCEDURES

3-4. GENERAL. Operator maintenance is limited to servicing and secondary type maintenance on the commercial

equipment. These service and maintenance procedures are outlined in the commercial publications supplied with the

various items of equipment. This section contains those procedures not covered by commercial publications and

deemed operator's responsibility. You should call organizational maintenance for any other maintenance requirements

on the editorial shelter.

3-5. SAFELIGHT ASSEMBLY.

This task covers:

Inspect

Replace

INITIAL SETUP

Tools

None

Material

Fluorescent light bulbs

a. Inspect (See Figure 3-1.)

(1) Inspect light fixture for broken bulb.

(2) Place light switch circuit breaker in ON position and check light for operation.

b. Replace. (See Figure 3-1.)

(1) Remove lamp (1).

(2) Install lamp (1) in light fixtures by aligning lamp contacts with slots in both ends of lamp fixture and

turning one-quarter turn clockwise.

Figure 3-1. Safelight Assembly Lamp

3-7/(3-8 Blank)