|
| |
Back
Figure 3-3. Power Distribution Box Assembly Cover Hinge | Up
TM-5-3610-294-13P Modular Printing System (MPS) Module C Press Section of the Army Special Warfare Modular Printing System Manual | Next
Table 3-1. Operator Troubleshooting |
TM 5-3610-294-13&P
SECTION II. TROUBLESHOOTING PROCEDURES
3-6. GENERAL.
a.
This section contains troubleshooting information for locating and correcting most of the Finishing Section. Each
malfunction for an individual component or unit is followed by a list of tests or inspections which will help you to
determine corrective actions in order listed.
b.
This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If a
malfunction is not listed, or is not corrected by listed corrective actions, notify your supervisor.
c.
Table 3-1 lists the common malfunctions which you may find during operation of the Finishing Section or its
components. You should perform tests or inspections and corrective actions in the order listed.
WARNING
High voltage exists in the electrical components of this equipment. DEATH on contact may result if
personnel fail to observe safety precautions.
NOTE
If you suspect a problem, you should first verify that the start-up procedures have been properly performed
before continuing with troubleshooting.
3-5
|
