|
| |
Back
Figure 2-11. Site Layout | Up
TM-5-3610-294-13P Modular Printing System (MPS) Module C Press Section of the Army Special Warfare Modular Printing System Manual | Next
Figure 2-13. Ceiling Light Assemblies, Stored Location (View Looking up at Ceiling) |
TM 5-3610-294-13&P
2-13. ASSEMBLY AND PREPARATION FOR USE. -Continued
c
Finishing Section Interior Equipment. Refer to Figure 2-12 for a typical location of Finishing Section equipment
when set up for operation. Remove the equipment from the center section of the shelter in the order listed below
using T-handle wrench, located to the right of the personnel door, to remove retainer bolts. Store retainer bolts in
proper location on transporter assemblies.
NOTE
Equipment stored in the center section of the shelter, with the exception of the paper cutter, may be placed
anywhere within the shelter.
(1)
Paper storage rack
(2) Office cabinet
(3) Folding chair
(4)
Shelf table
(5) Paper storage rack
(6) Stools and waste cans
(7) Floor mat (place between paper cutter and air conditioner units)
(8) Light table
(9) Developing tray
(10) Platemaker
Figure 2-12. Operating Location of Finishing Section Equipment
Change 1
2-23
|
