|
| |
Back
ASSEMBLY AND PREPARATION FOR USE. - Continued | Up
TM-5-3610-293-13P Modular Printing System (MPS) Module B Press Section of the Army Special Warfare Modular Printing System Manual | Next
Figure 2-18. Setting Up Sink Assembly |
TM 5-3610-293-13&P
2-14. ASSEMBLY AND PREPARATION FOR USE. Continued
(16)
Open hot and cold faucets (7) and place drain pump switch (16) in ON position. When hot water tank
and fresh water tank are empty, place drain pump switch (16) in OFF position.
WARNING
The sink assembly rear door must not be opened when power cable is connected.
Failure to comply may result in DEATH or serious injury.
(17)
Place all switches in OFF position, turn off hot and cold faucets (7), and disconnect and stow drain hose
(13).
(18)
Disconnect sink assembly power cable (17) from wall outlet (18) and open rear door (19). Fully close hot
water tank drain valve (20) and close rear door (19).
2-38
|
