ASSEMBLY AND PREPARATION FOR USE.

TM 5-3610-293-13&P 2-14. ASSEMBLY AND PREPARATION FOR USE. - Continued e. Setting Up and Operating Sink Assembly. (See figure 2-18.) (1) Remove portable pump (1), 25-foot hose (2), and 50-foot hose (3) from storage locations in ink cart and tool caddy assembly. (2) Place portable pump (1) outside personnel door, connect 25-foot hose (2) to portable pump outlet and connect 50-foot hose (3) to portable pump inlet. (3) Connect other end of 25-foot hose (2) to sink assembly inlet (4) and connect other end of 50-foot hose (3) to water source. (4) Verify that all switches are in the OFF position and that sink assembly power cord is connected to wall outlet and place water level switch (5) in FRESH WATER LEVEL position. (5) Connect portable pump electrical cord to exterior 120v outlet (6) on shelter power input panel. (6) Open hot water faucet (7), push press to test switch (8), and monitor water level on water level monitor (9). As soon as water level monitor (9) starts indicating, place fresh water pump switch (10) in ON position. (7) When water starts pouring out of faucet (7), close hot water faucet (7) and open cold water faucet (7). When water starts pouring out of faucet (7), close cold water faucet (7). (8) When fresh water tank is full (sound level of portable pump (1) will change or sound of water entering fresh water tank will change), disconnect portable pump electrical cord, disconnect 25-foot hose (2) and 50-foot hose (3). Stow portable pump (1) and hoses in ink cart and tool caddy assembly. CAUTION If thermometer indicates temperature in hot water tank is above 170°F, place water heater switch in OFF position and notify Unit Maintenance. Failure to do so may result in damage to equipment. (9) Place water heater switch (11) in ON position. The water heater will take approximately 10 minutes to fully heat the water in the hot water tank. Check thermometer (12). Water temperature should be 160°F or less. 2-36