CHAPTER 2. OPERATING INSTRUCTIONS

TM 5-3610-293-13&P CHAPTER 2. OPERATING INSTRUCTIONS SECTION I. DESCRIPTION AND USE OF OPERATOR'S CONTROLS AND INDICATORS 2-1. POWER DISTRIBUTION PANEL Refer to Figure 2-1 for location of controls and indicators. Numbers in parenthesis after control or indicator listed below appear as callouts in figure. a. Circuit Breaker (1) - Provides overload protection for interior utility outlets mounted on left rear wall and air conditioner room light. b. Circuit Breaker (2) - Provides overload protection for interior utility outlets mounted on hinged right front and rear walls and emergency light outlet. c. Circuit Breaker (3) - Provides overload protection for interior utility outlets mounted on left front wall. d. Circuit Breaker (4) - Provides overload protection for 36,000 BTUH air conditioner supply receptacle mounted on power entry panel. e. Main Circuit Breaker (5) - In ON position, delivers electrical power to individual circuit breakers. In OFF position, turns off all electrical power in shelter, except for the phase monitor assembly. f. Circuit Breaker (6) - Provides overload protection for ground fault interrupter utility outlet mounted on power entry panel. g. Circuit Breaker (7) - Provides overload protection for ceiling lights and blackout warning system. h. Circuit Breaker (8) - Provides overload protection for printing press. i. Circuit Breaker (9) - Provides overload protection for 24,000 BTUH air conditioner. j. Blackout Override Switch (10) - In the ON position, overrides door activated blackout switch mounted on the front wall adjacent to the personnel door. During blackout conditions switch must be in the OFF position. k. Incandescent Light Switch (11) - In the ON position, turns on left front wall light. In OFF position, turns off left front wall light. 2-1