 |
|||
|
|
|||
|
Page Title:
REMOVE/REPLACE CHARACTER BAND - continued |
|
||
| ||||||||||
|
|
  TM 11-7025-232-10
2-10. REMOVE/REPLACE CHARACTER BAND (CONT)
4. S l i d e band over right band pulley.
5. Position band between band
t r a n s d u c e r and pulley.
6. Move band down until bottom edge of
band rests on edge guide bearing
n e x t to each pulley.
·
Right edge guide bearing is
l o c a t e d in front of pulley
·
Left edge guide bearing is
l o c a t e d at rear of pulley
7. Move band release handle toward
f r o n t of printer, as shown.
8. W h i l e spinning either pulley in
direction shown, observe movement of
character band over both edge guide
bearings.
·
If character band touches, and
rides smoothly and evenly over
both edge guide bearings, go to
step 9
·
If character band does not touch
one or both edge guide bearings,
remove band and repeat steps 1
t h r u 7. If problem remains,
n o t i f y your supervisor that
m a i n t e n a n c e is required
·
If character band rides unevenly
or roughly over one or both edge
guide bearings, remove band and
repeat steps 1 thru 7. I f p r o -
b l e m remains, notify supervisor
t h a t maintenance is required
9. Close band cover.
10. R e p l a c e ribbon cartridge (para 2-9,
R e p l a c e , steps 2-14).
11. Lower hammer bank latch handle and
p r e s s into locked position.
12. P u s h ac plug into outlet.
13. R u n self test (para 2-15, steps
5-35).
2-24
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals