Chapter 3. ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

TM 11-7025-210-23

CHAPTER 3

ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

Index of Maintenance Procedures

Paragraph No.

Title

Page No.

3-14

Remove/Replace Platen

Clean Photocell

Section I. REPAIR PARTS, SPECIAL TOOLS,

TMDE AND SUPPORT EQUIPMENT

3-1. COMMON TOOLS AND EQUIPMENT

For authorized common tools and equipment refer to the Modified Table of Organization and Equipment (MTOE)

applicable to your unit.

3-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT

Refer to TM 11-7010-203-23P for a complete listing and description of special tools, TMDE and support equipment

required by organizational maintenance. Also refer to appendix B for a list of tools pertaining to the line printer.

3-3. SPARES AND REPAIR PARTS

Refer to TM 11-7010-203-23P for a complete listing and description of spares and repair parts required for organizational

maintenance of this equipment.

Section II. SERVICE UPON RECEIPT

3-4. UNPACKING

Upon receipt of new equipment, check packing list and instructions for any precautions or specific unpacking procedures.

3-5. CHECKING UNPACKED EQUIPMENT

Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the damage on

SF 364, Discrepancy in Shipment Report. Check the equipment against the packing slip to see if the shipment is complete.

Report all discrepancies in accordance with the instructions of TM 38-750. Check the equipment to ensure that required

Modification Work Orders have been applied in accordance with DA PAM 310-1.

3-1