PREPARATION FOR MOVEMENT

TM 11-7025-210-10

2-14. PREPARATION FOR MOVEMENT

Your system manual contains instructions for preparing the line printer for movement. In most installations, the platen,

unused paper, re-inker, and sometimes the ribbon cartridge are removed and stored to prepare the line printer for

movement.

2-15. OPERATING INSTRUCTIONS ON DECALS AND INSTRUCTION PLATES

There are many decals on the line printer. Only two are used by the operator. They are the RUN/LOAD lever and the VFU

tape decals.

a. RUN/LOAD Lever Decal. This decal is located near the RUN/LOAD lever (fig. 2-9) and shows how the lever must

be set for RUN (R) or for LOAD (L).

b. VFU Tape Decal. This decal (fig. 2-9) is located on the VFU assembly and

Figure 2-9. Operation Decals

2-29