Section II. OPERATING INSTRUCTIONS

TM 11-6780-225-12

Figure 2-6. Door safety lock release.

Section II. OPERATING INSTRUCTIONS

the discs are seated so that the reel turns freely (fig. 2-

2-6. Planning Mission

7, step 2).

a. Semiautomatic Film Loader. 35-mm, No. 220

film may be loaded into the reels by following -the

(3) Turn out the lights and remove film.

instructions given below and referring to figure 2-7.

(4) Slide the end of film from right to left into

(1) Hold the reel in the left hand with the ends

the curved loading guide, with emulsion side facing

of the outermost spiral wire facing to the right (fig. 2-7,

away from guide (downward). Insert film until enough

step 1).

film projects out of left side of guide to -almost reach the

center core of the reel.

(2) Holding the semiautomatic film loader

(loader) in the right hand, force the two discs of the

(5) Turn the reel in either direction until the

loader over the outside of the reel and snap them in

open side of its center core is felt to face the film end

place on center axis of reel, with the loading guide

projecting from the loading guide.

curved downward and to the right of the reel. Make sure

2-7