Figure 2-2. Top plate assembly locked in open position.

TM 11-6730-235-12

tioned, see if it has been changed by a modification work

cord to reach without applying any tension to the

order (MWO). If modified, the MWO number is marked

projector.

on the projector.

c. Locate the projector at a distance (from 4 to 25 feet)

from the projection surface that produces a projected

2-3.

Installation

image large enough to be seen by the full class or

Installation of the projector set consists of setting it up for

audience.

operation.

d. Do not obstruct the louvers at the front and rear ends

a. Place the projector on a surface that is at least 24

of the case assembly; a free flow of air must be

inches wide and 30 inches deep.

maintained.

b. The line cord is 15 feet long; locate the projector

close enough to a 110-volt, 60-Hertz (Hz) power

e. Make sure that no articles on the projector mounting

convenience outlet to permit the line

surface obstruct the holes in the bottom

Figure 2-2. Top plate assembly locked in open position.

2-3