Section II. PRELIMINARY PROCEDURES

Section II. PRELIMINARY PROCEDURES

Removing Camera from Everready Case

2-3.

a. Take the camera from its set carrying case (fig.

b. With the everready case in an upright position,

unfasten the snap fastener on the rear.

c. Lift the case top up, and over the camera front.

d. Turn the retaining screw, on the bottom of the

e v e r r e a d y case, c o u n t e r c l o c k w i s e until it disengages

t h e camera.

e. Lift the camera out of the case.

2-4. Mounting and Removing Lens

a. Mounting Lens.

CAUTION

Before mounting a lens, check to see that the red

dot inside the lens mount below the mirror is cov-

ered. If the red dot is visible, turn the mirror

lock lever (fig. 2-3) counterclockwise to the white

rectangle. While attaching the lens, make sure

that the self-timer lever is not moved clockwise

from its white dot. While holding lens barrel, in-

sure that bayonet mount ring (fig. 2-3) is turned

fully counterclockwise and will not turn clockwise.

( 1 ) Place the lens on the camera body with the

r e d dot on the bayonet mount ring lined up with the

red dot on the body.

( 2 ) Lower the lens onto the body. (The bayonet

mount ring should turn slightly clockwise by itself. )

( 3 ) Turn the bayonet mount ring as far clock-

wise as you can.

2-9