Bounce Flash

when the head is used in either TELE or WIDE

positions.

(12) To photograph a subject using a zoom

setting proceed as follows:

(a) Using ASA 100 film, set the flash unit

zoom/bounce head to TELE position.

(b) Set the flash unit mode selector dial to

the blue position.

(c) Set the camera lens to f8 position.

(d) Your automatic operating range is now

2 to 18-feet (0.7 5.5m), instead of 2 to 15-feet

(0.7 4.4m) as in the NORM position.

b. Bounce Flash. When the flash unit zoom/

bounce head is set to 45, 60, 75 or 90 degrees, the

light can be bounced off the ceiling or another re-

flective surface to create a softer light. When

using color film, keep in mind that the bounced

light will take on the color of the reflective sur-

face. Unless you are creating a special effect,

make sure you only bounce the light off white or

neutral colored surfaces. As a general rule, set

the tilt angle of the head so that the light is di-

rected at the midpoint between the flash unit and

the subject.

(1) Set the camera shutter speed dial at 60.

(2) Set the flash unit zoom/bounce head to

NORM position.

(3) Set the calculator dial, on the flash unit,

1-23