Figure 3-9. Removing print.

TM 11-6720-248-12

out of the camera to expose the yellow tab.

(2) Grasp the protruding yellow tab (fig. 3-8)

and pull the film, with a straight, continuous motion, out

of the camera.

(3) After a period of 60 seconds, grasp the

corner of the print and carefully remove the print from the

film (fig. 3-9). Handle the print only by its edges.

(4) Allow the print coating to dry.

(5) Trim the pictures to the required size.

3-8. Stopping Procedure

a. Temporary Shutdown. If the camera set was

connected for ac operation (para 3-4), place the power

switch (fig. 3-4) of each strobe assembly, to C (Model

600) or OFF(Model 700). If the camera set was

connected for battery operation (para 3-5, , proceed as

follows:

(1) Connect a power cord to each of the

strobe assemblies and to the 115-volt ac, 50to 60-Hz

power source.

(2) Place the power switch of each strobe

assembly at C (Model 600) or OFF(Model 700)

(3) With the strobe assemblies connected to

the ac power source and the power switches in the C

position (Model 600) or OFF(Model 700) ac power will be

supplied to the battery-charging circuit of each strobe

Figure 3-9. Removing print.

assembly. Under normal conditions, the battery-charging

circuit will recharge the batteries during a 16hour period.

b. Sixteen-Hour or Longer Shutdown.

If the

entire print surface with firm, overlapping strokes.

camera set will not be used again the following day, or

(6) Allow the print coating to dry.

later, perform the procedure in a above; then, proceed as

(7) Trim the four pictures to the required size.

follows:

(1) Disconnect the power cord from the

3-7. Operation Using Color Film

strobe assemblies and the 115-volt ac, 50to 60Hz power

source.

(2) Remove the titleboard (fig. 1-3) from the

NOTE

titleboard holder assembly by pushing the button on the

Do not attach the neutral density filter

titleboard holder.

on the camera lens assembly and do

(3) Rotate the horizontal positioning bar

not cover the strobe assembly lens

counterclockwise and withdraw it from the front socket of

with the mask. The twist lock filters

the camera housing.

must remain on both strobe

(4) Loosen the thumbscrew and remove the

assemblies.

stereoscopic attachment from the camera housing.

a. Attach the stereoscopic attachment (para 3-6b).

(5) Disconnect the shutter cord (fig. 1-2) from

b. Load the camera (para 3-6d, e, and f).

the lens and shutter assembly.

c. Adjust the shutter and diaphragm and

(6) Disconnect the flash cords from the strobe

photograph the subject (para 3-6g and h).

assemblies.

d. After two pairs of photographs have been made

(7) Remove the strobe and clamp assemblies

on the same frame of film, process the print as follows:

(fig. 1-3) from the dual strobe support arm assembly.

(1) Grasp the protruding white film tab (fig. 3-

7) and pull the strip, with a smooth, continuous motion,

3-6