Figure 3-4.1. Strobe assembly, rear view, model 700.

C 1, TM 11-6720-248-12

be photographed in a relatively long time period. The

additional, fully charged battery trays. If the condition is

strobe assembly is capable of approximately 80 flashes

anticipated, the spare battery trays are charged overnight

before it is necessary to recharge the batteries.

in the external charger and usually will provide 8 hours of

heavy operation.

a. Place the power switch to B (Model 600) or to

a. Insert battery trays into charger until they latch in

ON (Model 700).

b. The neon indicators will light when the strobe

place.

assemblies are ready to be fired.

b. Connect charger power cord to 115 volts ac, 50

to 60 Hz source.

3-5.1. External Battery Charger

When battery operation is required in locations with ac

c. If batteries are quite low, rotate timer knob to

power unavailable at the photo site, the external battery

maximum time, otherwise set timer to charge time

charger is used to provide four

required to bring batteries up to full charge.

d. Red lamp glows until time has elapsed, the time

automatically turns off when time has elapsed.

Figure 3-4.1. Strobe assembly, rear view, model 700.

3-4