9Shutter Cable Release Installation and Adjustment

TM 11-6720-239-35

Finder assembly, adjustments.

(3) When gauge is fully depressed, shutter

(3) If further adjustment is required, turn

the right-hand image adjusting screw at the rear

should trip.

(4) Re-cock the shutter. Center the recessed

of the mirror. Turning this screw in will move the

image to the right, and turning screw out will

end of "Go-No-Go" gauge over shutter release

movethe image to the left.

knob.

(5) When gauge is fully depressed, shutter

f. Shellac all lenses, except the mirror, into po-

should not trip.

sition.

c. Installation and Adjustment of Shutter Cable

Release.

3-22. Shutter Cable Release Installation and

(1) Insert shutter release return spring and

Adjustment

shutter release knob into shutter release bushing.

a. General. The shutter release cable must be

(2) Depress shutter release knob until the

the correct length to allow proper tripping action,

bottom edge is even with the top edge of the shut-

without being so long that the shutter release

ter release bezel.

knob can be accidentally tripping.

(3) Position shutter release tip on the oppo-

b. Operational Camera Check.

site end of the cable and crimp in place.

(1) Open camera and cock the shutter.

(4) Insert shutter release cable assembly into

(2) Place the small radial end of "Go-No-Go"

camera body. Shutter cocking arm should be in

the up or uncocked position.

gauge against the shutter release knob.