Technical Characteristics

j. PO wer Cable (fig. 2) . The power cable consists of 15 feet of hard

service cord containing two stranded wire conductors. On one end is a

molded male connector and on the other is a molded female connector.

6. Technical Characteristics

Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..Opaque object

Projection lamp . . . . . . . . . . . . . . . . . . . . . . . . .1,000-watt, 115-volt, T-20 medium

prefocus, C13 filament.

Projected image . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. From 34 by 34 in. at 7.5 ft. to

120 by 120 in. at 22½ ft. (using

10 by 10 in. aperture) .

Fan motor . . . . . . . . . . . . . . . . . . . . . . . . . 115-volt ac, 60-cycle, single phase,

open construction, shaded pole.

Power supply . . . . . . . . . . . . .. . . . . . . . . 115.volt ac, 60-cycle.

Projection lens . . . . . . . . . . . . . . . . 22 in. effective focal length,

in. dia.

7. Additional Equipment Required

A projection screen is required. Any type of semimatte screen may

be used. A flat, light-colored wall surface will give fair results if no

screen is available.

8. Packaging and Packing Data

Still Picture Projector AP-5 (1) with its components and accessories

are placed within the designated compartments in the carrying case

(fig. 2). The cover of the carrying case is closed and secured with its

four fastenings. The carrying case is cushioned at each corner and at

the top and bottom with fiberboard inserts and is placed within a

waterproof, fiberboard carton. The entire closure is sealed with water-

proof tape. The packaged equipment is placed within a second corru-

gated carton and sealed with gummed tape.