Replacement

Page 45, paragraph 49 a (2) (a). Change "(figs, 1 and 8)" to:

(figs. 1,8, and 8.1).

Page 46, paragraph 49 b (3) Add the following subparagraphs:

(b. 1) For the AP-5(2), if the arrow cannot be seen over

the entire picture area, optical alinement is necessary.

To aline the optical pointer assembly, remove the front

panel (par. 46.1 c (1) (b) and (c)), Loosen the ad-

justing screw (fig. 16.1) on the rear surface mirror

mounting. Adust the rear surface mirror mounting

by sliding it toward the projector housing or away

from the projector housing until the arrow can be

positioned by the pointer knob over the entire picture

area.

(c. 1) For the AP-5(2), replace the front panel.

Paragraph 49(4). Add the following subparagraphs:

(b.1) For the AP-5(2), remove the front panel (par.

46.1 c (1) (b) and (c)). Loosen the lens collar screws

(fig. 16.1). Focus the arrow by sliding the lens collar

back and forth on the lens tube until the arrow image

is in sharp focus on the projection screen.

(c. 1) For the AP-5(2), replace the front panel.

Page 48, paragraph 55a. Change'' (fig. 2)'' to: (figs. 2 and 2.1).