OFF-FAN ONLY-ON Switch.

(b) Remove the front panel and (c) a b o v e ) .

(c) Remove the lamp socket screws (fig. 14.1).

(d) Lift the projection lamp socket out of its mounting

hole (fig. 4.1).

(e) Disconnect the two leads from the base of the projec-

tion lamp socket.

(f) Remove the projection lamp socket from the projector

housing.

(2) Replacement. Replace the projection lamp socket by

reversing the procedures in (1) above.

h. OFF-FAN ONLY-ON Switch.

(1) Removal.

(a) Remove the front panel (c (1) (b) and (c) above).

(b) Loosen the knob setscrew ( not shown) and remove the

knob of the OFF-FAN ONLY-ON switch (14, fig. 5.1).

(c) Remove the hexagonal nut and lockwasher (not

shown) from the switch.

(d) Slide the switch out of the mounting hole and discon-

nect the leads.

(e) Remove the switch from the projector housing.

(2) Replacement. Replace the OFF-FAN ONLY-ON switch

by reversing the procedures in (1) above.

i. Fuses ond Fuseholders (fig, 14.1). The following procedures

apply to each fuse or fuseholder:

(1) Removal of fuse.

(a) Push in on the fuse cap and twist it to the right (coun-

terclockwise).

(b)) Pull the fuse cap out of the fuseholder.

(c) Remove the fuse from the fuse cap.

(2) Replacment of fuse. Replace the fuse by reversing the

procedures in (1) above.

(3) Removal of fuseholder.

(a) Remove the front panal (c (1) (1)) and (c) above)

(b) Disconnect the two wires from the fuseholder.

(c) Remove the hexagonal nut and lockwasher (not

shown) from the fuseholder.

(d) Remove the fuseholder.