 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  b. Copy Feeding Unit.
(1) Removal (fig. 10.1).
(a) Remove the four copy feeding unit attaching screws.
(b) Lift the copy feeding unit out of the undercarriage.
(2) Disassembly (fig. 11.1).
(a) Remove the two sheet metal screws (1) and speed nuts
(2).
(b) Remove the orifice plate (3).
(c) Slide the copy feed belt (4) off the rollers (9 and 13).
(d) Remove the screw (5) and washer (6).
(e) Remove the idler roller (9) from the body assembly
(14).
(f) Slide the two roller adjustment strips (7) and spacers
(8) off the idler roller (9).
(g) Loosen the setscrew (10) and slide the drive roller
(13) and spacers (12) off the handcrank (11).
(h) Slide the handcrank (11) out of body assembly (14).
(3) Reassembly. Reassemble the copy feeding unit by re-
versing the procedures in (2) above.
(4) Replacement. Replace the copy feeding unit by revers-
ing the procedures in (1) above.
c. Blower Assembly.
(1) Removal.
(a) Place the projector on its left side (viewed from the
rear).
(b) Remove the panel mounting screws (17, fig. 5.1 ) that
hold the bottom and front panels (20 and 22) to the
projector housing.
(c) Remove the bottom and front panels.
(d) Remove the four blower assembly mounting screws
(not shown ) from the bottom of the projector.
(e) Slip the tailpipe (fig. 8.1 ) off the right blower scroll
(2, fig.12.1).
(f) Slide the blower assembly out of the projector housing.
(2) Disassembly (fig, 12.1).
(a) Remove the seven screws (1) that hold the right
blower scroll (2) to the motor housing (10).
(b) Remove the right blower scroll (2).
(c) Remove the seven screws (1) that hold the left blower
scroll (3) to the motor housing (10).
(d) Remove the left blower scroll (3).
(e) Loosen the setscrews (not shown) on the two blower
wheels (4) and slide the blower wheels off the shafts
of the blower motor (9).
AGO 5802-B
16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals