Figure 9.1. (Added) Projector, Still Picture AP5(2), schematic diagram.

Figure 9.1. (Added) Projector, Still Picture AP5(2), schematic diagram.

Page 34.

44.1. Lens Tube and Lens Mount, Still Picture Projector AP-5(2)

(fig. 5.1)

(Added)

a. Lens Tube.

(1) Remove the lens tube ( 19) from the lens mount (3) by

loosening the lens clamp screw (4) and carefully sliding

the lens tube (19) out of the lens mount (3).

(2) Replace the lens tube (19) in the lens mount (3) by re-

versing the procedure in (1) above,

b. Lens Mount.

(1) Removal.

(a) Remove the lens tube (a (1) above).

(b) Remove the stop screw (6) from the rack (7).

(c) Rotate the focusing knob (1) to the right until the

pinion shaft (16) is disengaged from the rack (7).

(d) Slide the lens mount (3) off the rack (7).

(e) Slide the receiver assembly (21) from the channels

(2).

(2) Replacement. Replace the lens mount by reversing the

procedures in (1) above.

c. Focusing Knob.

(1) Removal.

(a) Loosen the two setscrews (not shown) in the collar of

the focusing knob (1),

(b) Slide the focusing knob (1) off the pinion shaft (16).

(2) Replacement. Replace the focusing knob by reversing

the procedures in (1) above.

AGO 5802B