Carrying Case - continued

TM 11-2323

Page 12, paragraph 10. Make the following changes :

Heading. Change "(tips. 5 and 6)" to: (fig. 5, 5.1, and 6). Sub

paragraph b, line 1. After the first sentence. add: On the PH-

637C/PFP, unlatch the four fasteners and lift off the cover.

Page 14. paragraph 11. Make the following changes :

S u b p a r a g r a p h b ( p a g e 6 o f C 2 . Delete subparagraph h and

substitute :

b. Open the carrying case and remove the projector housing. Set

the housing on the support (II above) so that the support post end

is away from the projection screen.

Subparagraph c, line 1. Change "Loosen the head-support" to :

On the PH-637/PFP, PH-637A/PEP, and PH-637B/PFP,

loosen the support.

Add subparagraph c.1 after subparagraph C:

c.1. On the PH-637/PFP, loosen the clamping knob (tip. 7.1 )

and insert the support post (fig. 2.2) through the hole in the upper

locating bracket. The rack should be at the top of the support post.

facing toward the project ion stage. Slide the support, post down

until its bottom is engaged in the lower support bracket and the locat-

ing pin (on the support post ) is engaged in the notches of the upper

locating bracket. Secure the support post by tightening the clamping

knob (fig. 7.1).

Subparagraph e, line 1 and last sentence (page 6 of C2).

Change

"(PH-637/PFP

and

PH-637A/PFP)"

to:

(PH-637/

PFP, PH-637A/PFP, and PH-637C/PFP).

Line 8. Change "(fig. 7)" to: (fig. 7 and 7.1).

Page 15. Add figure 7.1 after figure 7: