Additional Repair Parts Authorization

theater headquarters or communication zones to provide theater com-

munications, those repair parts authorized up to and including general

support are authorized for stockage by the organization operating this

equipment.

3. Additional Repair Parts Authorization

An asterisk (*) in the column titled "15-Day Maintenance Allowance

per 100 Equipments" indicates that an item is not, authorized for stockage

but if required, may be requisitioned for immediate use only.

4. Requisitioning Information (organizational)

a. The allowance factors are baaed on 100 equipmenta. In order to

determine the number of parts authorized for the specific number of

equipments supported, the following formula will be used and carried

out to two decimal places.

Specific number of equipments supported

allowance factor

= Number of parts authorized.

100

b. Fractional values obtained from above computation will be rounded

to whole numbers as follows:

(1) When the total number of parts authorized is less than one, the

quantity authorized will be one.

(2) For all values above one, fractional values below 0.5 will revert

to the next lower number, fractional values of 0.5 or larger will

advance to the next higher whole number.

c. The number of parts authorized, determined after application of

a and b above, represent one prescribed load for a 15-day period. The

items and computed quantities thereof must be on hand or on order at

all times.

d. Major commanders will, determine the number of prescribed loads

second echelon units and organizations will carry. Unit and organiza-

tions authorized additional prescribed loads will utilize the formula

explained in a above but, will multiply the number of equipments sup-

ported by the number of authorized prescribed loads before completing

the formula. Fractional values will be rounded to whole numbers as

described above.

5. Requisitioning lnformation (Direct and General Support)

a. The allowance factors are based on 100 equipments. In order to

determine the number of parts authorized for initial stockage for the

specific number of equipments supported, the following formula will be

used and carried out to two decimal places.

allowance factor

Specific number of equipments supported X

-Number of parts authorized for initial stockage.

TAGO 7114-B