|
| |
Back
Figure 2-3. Color Press Controls | Up
TM-10-3610-203-14 Press Shelter Unit of the Transportable Special Warfare Printing Plant Manual | Next
Figure 2-4. Papercutter Controls. |
TM 10-3610-203-14
c.
Papercutter. An Alton Iron Works Model 4906 guillotine type paper cutter is mounted toward the rear of the
bench assembly and is electrically operated and hydraulically powered. Electrical power to the unit is controlled by a
two-position switch in the upper left corner of the front panel. (See fig. 2-4.) An indicator light illuminates when the
power switch is positioned to on. Two pushbutton type cutter operating switches, also located on the front panel, must be
depressed simultaneously in order to operate the cutter blade. When the blade reaches the bottom of the stroke, it will
reverse automatically and return to the starting position. The cutting stroke will not be repeated until the control switches
have been released and again depressed. A scale located at the right section of the cutter base, is used to measure the
size of paper to be cut. When measured cuts less than 4 inches (10.16 cm) are required, a spacer block should be
installed in front of the back gage.
2-5
|
