|
| |
Back
Figure 4-9. Storage Compartment, Removal and Installation | Up
TM-10-3610-202-14 Editorial and Photochemical Shelter Unit The Transportable Special Warfare Printing Plant Manual | Next
Figure 4-11. Wall Cabinet, Removal and Installation |
TM 10-3610-202-14
(6)
Remove the storage compartment.
c.
Installation To install the storage compartment
proceed as follows:
(1)
Place
storage
compartment
against
shelter wall and align mounting holes.
(2)
Secure with blind rivets.
(3)
Move composing machine and stand
assembly against shelter wall and align mounting holes.
(4)
Install two mounting bolts.
d.
Repair. Repair of the storage compartment
consists of removing minor dents.
a.
Inspection Inspect the wall cabinet assembly
as follows:
(1)
Inspect cabinet for dents or cracks and
any other signs of structural damage.
(2)
Inspect welded areas for breaks or
separation of weld seams.
(3)
Inspect cabinet handles for security of
installation and damage. Repair or replace as
necessary.
(4)
Inspect paintwork for any signs of peeling
or cracking and check cabinet for evidence of
environmental damage.
(5)
Inspect cabinet assembly for
4-20. Wall Cabinet Assembly.
The wall cabinet assembly is a two-shelf unit of
metal construction mounted on the left-hand wall
towards the front of the shelter. Two hinged doors with
control rod type latches provide access to the cabinet
interior. Removable steel rods extend above and
parallel to the shelves to help retain cabinet contents.
Two rubber protective guards are installed on the lower
front corners of the cabinet. (See fig. 4-10.)
security of mounting. Repair as necessary.
(6)
Inspect shelves for bends, cranks or other
damage.
(7)
Inspect content retaining rods for damage
and security of installation. Repair or replace as
necessary.
(8)
Inspect latching mechanism and latching
rods for freedom of movement, security of installation
and signs of damage. Repair or replace as necessary.
(9)
Inspect doors and hinges for freedom of
movement and damage. Replace as necessary.
(10)
Inspect
rubber
guard
protector
for
4-28
Figure 4-10. Wall Cabinet assembly
|
