TM 10-3610-202-14 (4) Lift   cabinet   shell   away   from   wall   and remove from shelter. (5) Remove locking bar from upper and lower clips of new cabinet and remove all drawers. (6) Using  heavy  paper,  construct  a  mounting hole   location   template   by   placing   the   paper   on   the removed cabinet and marking mounting holes. (7) Using    the    template    as    a    guide,    drill mounting holes in the replacement cabinet. (8) Remove   contents   from   all   old   cabinet drawers and install drawers in cabinet. (9) Install    locking    bar    through    upper    and lower clips. NOTE When     cabinet     is     mounted     In shelter,  the  locking  bar  rests  on the floor when Installed in locking clips    When    lifting    the    cabinet, ensure that bar Is held in position to prevent movement of drawers. c. Installation     Install  new  cabinet  assembly  as follows: (1) Position  cabinet  against  left-hand  shelter wall   and   align   cabinet   holes   with   mounting   nutplate holes. (2) Install   the   four   bolts   which   attach   the cabinet shell to the welded nutplates. (3) Install all drawers in their correct location. (4) Install    locking    bar    through    upper    and lower clips. d. Repair.    Repair   of   the   file   cabinet   assembly includes    replacement    of    drawer    handles    and    label holders and minor repairs to the locking bar. (1) Drawer  handle  replacement.      Replace drawn.  handles as follows: (a) Remove  locking  bar  from  upper  and lower clips. (b) Open applicable drawer. (c) Remove  the  two  screws  which  attach the handle from the inside of the drawer and remove the handle NOTE The top drawer handle attachment screws  are  located  in  a  small  top drawer    compartment.        A    short screwdriver is required to remove these screws. (d) Position handle on cabinet drawer and install attaching screws. (e) Install  drawer  contents,  close  drawer and install locking bar through upper and lower clamps. (2) Label    holder    replacement.        Replace label holders as follows: (a) Remove the two screws attaching the label  holder  to  the  front  of  the  drawer.    Remove  the holder. (b) Position the label holder to the drawer mounting location and install attaching screws. (3) Locking    bar    repair.        Repair    of    the locking  bar  is  limited  to  straightening  of  minor  bends. This  can  best  be  accomplished  by  placing  the  bar  in  a vise and applying pressure to the damaged area. 4-19.  Storage Compartment. The  stainless  steel  storage  compartment  mounted  on the  lower  forward  roadside  wall  of  the  shelter  provides storage    for    the    vertical    camera    accessories.        The storage compartment has three portions to separate and protect the camera accessories.  It is also equipped with a strap-type cover with pull-type latch. a. Inspection    Inspect  the  storage  compartment for  security  of  attachment,  cracks,  dents,  and  condition of strap-type cover and latch.  Replace as required. b. Removal  To remove the storage compartment proceed as follows: (1) Remove contents from the storage compartment. (2) Remove   the   composing   machine   stand assembly as described in paragraph 4-23. (3) Move     the     composer     and     composing machine  stand  assembly  to  the  right  to  allow  enough room to gain access to the storage compartment. (4) Drill out the six blind rivets at the bottom of the storage compartment. (5) Drill  out  the  11  blind  rivets  attaching  the storage compartment to the wall.  (See fig.  4-9.) 4-26