Figure 2-1. Air Conditioner Controls

TM 10-3610-202-14 Figure 2-1. Air Conditioner Controls 2-3. Operation. This paragraph provides generalized operating procedures for the information and guidance of the personnel responsible for the operation of the printing plant and the installed equipment. More detailed information pertaining to equipment operation is contained in the various commercial manuals supplied with the equipment. a. Platemaker. (1) The electrically operated NuArc 18V platemaker is shock mounted and ready for operation when the power cord is inserted into the applicable polarized wall receptacle. The flip-top vacuum printer frame is used to hold film securely against a sensitized plate while the image on the film is being printed on the plate. The vacuum for the flip-top printing frame is developed by a vacuum pump. (2) Due to installation requirements, the blower unit, used to ventilate the machine, which is normally mounted on the external side of the rear panel, is now located within the lower compartment. To gain access to the mercury vapor lamp mechanism, which is located directly above lower compartment, position flip-top frame in a vertical position to expose the lamp reflector. Remove the glass shield within the unit to expose the lamp mechanism for cleaning and replacement of vapor lamp tube. WARNING The mercury vapor lamp should not be operated above 110 of rated voltage. Such operation increases pressure within the lamp which could cause a tendency to shatter with subsequent ultraviolet output causing skin and eye irritation. 2-2